STOREMOLLA 5-drawer dresser, gray-brown stained, 24 3/4x19 5/8x51 5/8 "

STOREMOLLA 5-drawer dresser, gray-brown stained, 24 3/4x19 5/8x51 5/8 " — Assembly Overview

Drawer units look simple on the outside, but the internal hardware tells a different story. The STOREMOLLA 5-drawer dresser, gray-brown stained, 24 3/4x19 5/8x51 5/8 " takes an average of 2 hours and 5 minutes to assemble according to 2 buyers, rated easy in difficulty. With 5 drawers, the slide installation is the most time-consuming step — each pair needs to be level and aligned. Done right, you end up with a unit that opens smoothly for years.

Why this build takes as long as it does

Drawer slide installation is where most of the time goes on this build. Each slide needs to be mounted level relative to the others, so test each drawer fully before installing the next. The drawer fronts are the last step — attach them loosely, align visually, then tighten. Trying to align the front while the slides are off is a frustrating loop most first-time builders fall into.

⏱ Time Breakdown

Estimated split based on how real builds typically run

What usually slows people down

• !Installing all 5 slide rails level relative to each other — even 1–2mm off causes visible misalignment
• !Attaching drawer fronts before testing that each drawer runs smoothly
• !Mixing up similar-looking hardware across different drawers
• !Pulling fronts off to realign after they've been attached — it's inevitable if slides aren't checked first

🛠 How to Assemble It Faster

1. 1Treat the 5 drawers like an assembly line: install slide hardware on one side of every drawer box, flip them all, do the other side. Noticeably faster than one-drawer-at-a-time.
2. 2Install ALL slide rails into the carcass before building a single drawer. Test that they're level relative to each other first — fix alignment now, not after the drawers are built.
3. 3Attach drawer fronts last, screws loose. Align visually with drawers closed, then tighten. You won't get this right on the first try — and that's normal.
4. 4Mark the first completed drawer with tape on the inside — easy to lose track of which ones have been tested after building several.

Step-by-Step Assembly Guide

1. 1Assemble the outer carcass first — sides, top, bottom, and back panel.
2. 2Install drawer slide rails into the carcass. Check they're level side-to-side before tightening.
3. 3Build the first drawer box. Slide it in and test the full range of motion before building others.
4. 4Adjust slide rail height until the drawer face sits flush, then install remaining drawers.
5. 5Attach drawer fronts. Start with screws loose, align the front visually, then tighten.
6. 6Install any locks, handles, or soft-close bumpers last.

Common mistakes to avoid

• ✕Attaching drawer fronts before confirming each drawer runs smooth — removing fronts is annoying to redo
• ✕Mixing slide hardware between different drawers — slides are often identical but position-specific
• ✕Mounting all slides before testing the first drawer — a systematic error gets repeated across all drawers
• ✕Not testing soft-close bumpers before final installation

Frequently Asked Questions

Compared to similar IKEA builds

Easier alternatives to consider

If you want less assembly time or complexity

If you prefer IKEA's design and price point, the original is still a solid choice — just budget the extra setup time.

What affects assembly time

Is this worth assembling yourself?

Yes — this is well within DIY range for most people. The main risk is the drawer slide or slat alignment taking longer than expected on your first attempt. Budget the time, have a rubber mallet ready, and don't rush the alignment steps. Professional assembly for a build like this isn't necessary unless you're genuinely short on time.

More resources